UCS512 SOP8 IC Componenets for DMX 5v 12v 24v rgb leds
Support
Note: When configuring your pixel device, select ‘DMX512′ as your Pixel Type. This is the equivalent protocol that will allow you to use UCS512B pixels.
Technical Specifications
| Clock Type | Data-Only |
| Color Resolution | 8 bits |
| Physical Package | SOP8 |
| RGB | Yes |
| RGBW | See UCS2904 |
| Output Pixel Voltage | 5 – 24V |
| PWM Rate | 3000Hz |
| Suitable Camera | Up to 100fps, see Refresh Rate and PWM Rate |
| Data Transfer Rate | 250 – 750kbps |
| Redundant Data Line | No |
UCS512B Advantages
- High PWM rate allows for filming these pixels with cameras up to 100fps
- Up to 24V, allowing for very long cable lengths
UCS512B Disadvantages
- Data-only restricts refresh rates to be limited by the speed of the protocol, which will generally be slow
- Only 8 bits of data for each color makes dimming curves less smooth
- No redundancy in data
- Operation relies on addressing of the pixels to be correct from the factory (See Operational Behavior below)
Operational Behavior
UCS512B will work with the generic DMX512 protocol as is, but this assumes correct factory set addressing of the individual pixels (addressing is usually pre-set at the factory in the pixels themselves). There is also an external addressing line which could allow the team at Advatek to change the addressing via custom firmware development if required - contact the Advatek Support team to find out more.
Write your message here and send it to us
